Five characteristics of metal stamping die operation

2017/4/27 12:20:58

Hardware stamping die operation of the seven major features:

1, the production efficiency of the unit time to complete the number of parts or process content than the general processing several times higher, or even hundreds of times. And metal stamping process can also be used in a set of molds with a multi-piece, multi-process content processing to further improve the production efficiency.

2, product quality and interchangeability of the use of metal stamping die forming products, affecting product quality changes in the factors less low degree of harm. Some factors can take appropriate measures to be corrected, so that the quality of products within the desired range of j product quality stability can effectively ensure its interchangeability. Good interchangeability is the basic guarantee for the mass production of the assembly line. But also conducive to product maintenance, replacement.

3, high utilization of materials through different layout methods, such as: cross, oblique, multi-row, mixed, cut, and even no waste nesting way, can effectively improve the utilization of materials, reduce product cost of materials.

4, the material without heating Under normal circumstances, in the stamping operation, the material without heating. This will not only save energy, reduce the heating equipment and site occupancy, but also to avoid the surface of the product due to heating oxidation, burns and deformation caused by the shape of the size of instability. It is also possible to prevent the adverse effect on the mold due to the temperature rise.

5, the mechanical properties of the punch to be improved by the impact of hardening of the phenomenon of metal stamping, punching the surface of the organization closely, hardness and wear resistance increased, punching the strength and rigidity also increased.

6, to adapt to a wide range of suitable for a lot of stamping products. Can solve many general machining can not or difficult to complete the processing content, especially for some thin, soft, difficult, strange, miniature parts, or non-metallic materials, parts forming, metal stamping is almost the only forming method.

7, simple operation, low labor intensity of the product forming process and the basic quality of most of the mold and stamping equipment to ensure that the basic action when the operation is the same, and not affected by the complexity of the product. The operator is not too high technical requirements, the short-term job training, you can post operation.